Covid-19 Statement:

Due to COVID-19, we are currently experiencing longer than average order-processing times. Please expect a 5-7 day delay in order-processing times. We are doing our best to move quickly and efficiently, and we appreciate your patience and understanding. Thank you for shopping at New Rage Cycles.

  Home > Shop by Bike >

Ducati Scrambler Classic/Icon/Full Throttle/Urban Enduro Fender Eliminator Kit

Ducati Scrambler Fender Eliminator Kit


 
Alternative Views:


Our Price: $135.00

Availability:: Usually Ships in 24 to 48 Hours
Product Code: ICFU-FE

License Plate Location



Qty:  
Description
 
NRC releases a PLUG & PLAY fender eliminator kit for the entire Ducati Scrambler line of bikes! If you are looking to remove the rear fender, this is the kit for you! Our kit is sold as turn signals only (see photo #3), as well as a complete fender eliminator solution with a license plate bracket included (photo #1). If you want to keep the stock license plate, no problem! You can order just the signals with splash guard -- or add the license plate bracket and tuck it up underneath the bike.

Our plug & play kit saves you time and money on installation, and lets you plug right in and ride on!


Average Rating: Average Rating: 3 of 5 3 of 5 Total Reviews: 1 Write a review »

  0 of 0 people found the following review helpful:
 
3 of 5 Decent end result, but poor design. August 20, 2021
Reviewer: Ryan W. from Seattle, WA  
While the end result is good, dont expect to get there easily. With no instructions online for my specific bike, it makes it a lot harder when the brackets dont fit the bikes frame. With both the license plate attachment and the light bracket, the lights are supposed to go up into the frame, but due to poor design they did not fit and I was forced to put them upside down with the sponge material exposed. Also, the license plate bracket was not to the shape of the frame and so I had to bend it to fit. Be prepared to put the license plate on before you install on your bike too! This is because when screwing the license plate on, the bolts are just loose, which makes the nut impossible to tighten because to access the bolt head you have to take the whole bracket off. It would be better if the bolt heads were riveted on so you just have to tighten the nuts on.

Was this review helpful to you?