Covid-19 Statement:

Due to COVID-19, we are currently experiencing longer than average order-processing times. Please expect a 5-7 day delay in order-processing times. We are doing our best to move quickly and efficiently, and we appreciate your patience and understanding. Thank you for shopping at New Rage Cycles.

  Home > Shop by Bike >

Indian FTR 1200 Fender Eliminator

Indian FTR 1200 Fender Eliminator Kit

Alternative Views:

Our Price: $175.00

Availability:: Usually Ships in 24 to 48 Hours
Product Code: FTR-FE

MT-09 License Plate Location

Tucked or Side Mount License Plate*:

Take your Indian FTR 1200 to the next level with our DIY fender eliminator. NRC kit comes with LED replacement turn signals, license plate bracket, and LED license plate light for a full LED replacement.

Select from the dropdown field our Tucked version (as seen in main photos), or a Side Mount License Plate which mounts the plate down on the swing arm.

Comes with all necessary hardware to install, and OEM connectors to make for a simple bolt-on / plug-in fender eliminator.

Add a Dual-Load Equalizer to stabilize the flash speed. It is not required, but the turn signals will flash slightly faster than stock without some kind of resistor.

Average Rating: Average Rating: 5 of 5 5 of 5 Total Reviews: 2 Write a review »

  0 of 0 people found the following review helpful:
5 of 5 Best FTR upgrade available June 10, 2021
Reviewer: Brandon from Utah  
The OEM rear fender on the FTR kills the profile, and if you live in a non-draconian state that doesn't punish you for tucking your plate to a more ergonomic location then this here is a good looking and simple solution. The install instructions were sufficient and for the front + rear replacement it only took about 2 hours. I'm not sure about the older models but on my 2022 standard FTR the bolts that hold on the  license plate light needed to have the allen heads on the inside and nuts facing out or it absolutely will not fit correctly. That was the only issue I ran into. Highly recommended for all other FTR owners, this will not disappoint.

Was this review helpful to you?

  1 of 1 people found the following review helpful:
5 of 5 Installation May 17, 2020
Reviewer: Aaron from Michigan  
Just completed the install after a very minor issue with the product when it arrived. The staff at NRC jumped on it to make it 100%.  Cannot be used with the OEM side bag mount without modifying the framework of the mount, cutting/welding is required and one fastening support will be lost.
Wire harness routing instruction is vague and could lead to the routing being too close the the chain or exhaust if not paying attention. Take the time to route the OEM harness back to the main harness then run up inside the frame and next to the tank. Rear light leads will need to slide in under the tank and connect all fitting behind the tank (hence the need to remove the rear tank bolts- lift up a little on the tank to slide the leads up).  Plenty of room to make all the connections under the seat. Be careful not to damage any wires when reinstalling the seat bolts. Lights work flawless, components are of very high quality. Lights are very bright and are not overwhelmed by the led brake light.

Was this review helpful to you?