KTM SuperDuke 1290 Fender Eliminator (2020-Present) Instructions
KTM SuperDuke 1290 Fender Eliminator (2020-Present) Installation Instructions
1) Remove stock seats from bike
2) Remove 4 bolts holding on stock tail section using either a 8mm socket or T30 torx (Photo 1)
3) Slide grommet cover off and unplug 4 pin connector while also popping out rubber grommet (Photo 2)
4) Take new fender eliminator, slide harness through grommet hole (installing new grommet in its place) and use provided M6 nuts to mount kit into place. Clip off zip tie first as this is attaching the license plate bracket to the fender eliminator.
5) Plug connector in and test everything
6) Mount your license plate
Shop The Part
New Rage Cycles
KTM SuperDuke 1290 Fender Eliminator (2020-Present)
Take your KTM SuperDuke 1290 to the next level with our DIY fender eliminator. NRC kit comes with LED turn signals, license plate bracket, and LED license plate light for a full LED replacement. This newly updated 1290 was designed with a creative twist to it. Why not add to the styling with our unique and creative design?
Comes with all necessary hardware to install, and OEM connectors to make for a simple bolt-on / plug-in fender eliminator.
**Note some KTM models throw a code on the dash. We have not yet had a model in the shop that replicates this, so we do not currently have a solution. As soon as we can take a bike in that has this code, we will find a resistor that resolves this.**